Jump to content
The3DPrintStudio

Gcodes for starting script for UM3 using S3D

Recommended Posts

Posted · Gcodes for starting script for UM3 using S3D

The default starting script for simplify 3D is:

M106 S0 ; fan off

M204 S1500 ; default acceleration

M205 X15.00 ; maximum X Y jerk

T0

G1 X2 Y5 Z5 F15000.0 ; heating location

M140 S[bed0_temperature]

M104 S[extruder0_temperature] T0 ; heat left

M190 S[bed0_temperature]

M109 S[extruder0_temperature] T0 ; stabilize left

G1 Z0.2

G92 E0 ; zero extruder

G1 E30

G92 E0 ; zero extruder

G1 X100 E15 F1000 ; purge left extruder

I would like to modify this to still go to X2 Y5, but instead of purging the extruder from x2 to x100, do a Cura style purge where it just depositing a large blob of filament. I found this does a better job getting rid of any different color PLA when swapping colors. What would be the best way to change this to do that. I know G280 does the filament purge on the UM3, but I'm not sure what to remove/replace.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!