Jump to content
Rdrost

Dual Extrusion Fine Tuning

Recommended Posts

Posted (edited) · Dual Extrusion Fine Tuning

I am trying to print this dual extrusion print with white and black PLA. Any ideas on how to fine tune this to remove the mess on top? I have tried the ooze shield, prime tower, and changing the top level jerk settings (not sure this helped, but I tried it). Nothing has shown visible improvement yet. I am printing ultimaker PLA (white and black) on normal settings in cura (0.1mm layer height). IMG_20170417_081306.thumb.jpg.ac2ee974ee47cbed85756363e6facb83.jpg

IMG_20170417_081306.thumb.jpg.ac2ee974ee47cbed85756363e6facb83.jpg

Edited by Guest

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!