Jump to content
Ultimaker Community of 3D Printing Experts

Help? How do I fix this failure?


Recommended Posts

Posted · Help? How do I fix this failure?

Good news! Back in business. Very straightforward to fix a surprising failure. Looked much worse than it was. Used pliars and a needle-nose tweezers.

5a333631b6726_2017-04-1801_37_34.thumb.jpg.ba9c67bbfb9daab4f3a355902acf8537.jpg

5a3336321b229_2017-04-1801_37_41.thumb.jpg.1cdc9288f1d9d81d22d52633d984e0e7.jpg

I think I know what happened. The print that failed had support inadvertently turned off. The print must have broken off and blocked the nozzle, forcing the plastic back up into the chamber with the heated block.

I re-did the gcode file and re-ran the print, and it succeeded. Thank you very much for the pointer to the correctly defined problem. I was pretty sure something had broken above the nozzle, but it did not.

  • Link to post
    Share on other sites
    Posted (edited) · Help? How do I fix this failure?

    Yeah maybe it just unstuck from the bed and the print started to get dragged, that made the extrusion build up around the nozzle and keep crawling like a worm.

    Edited by Guest
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...