Jump to content
Ultimaker Community of 3D Printing Experts

Attention Software Issue with SD Card!!!

Recommended Posts

Posted · Attention Software Issue with SD Card!!!

Hello all,

I have a good SD card but have discovered that it can go wrong!

If I have sliced the part to be printed

In this case in Cura there is nothing going on (no problem)

But if I save it to my SD card and then put back in Cura again,

Then the print is no longer good!!!

Whether it is on the SD card.

The mistake I think is in the transition from PC to SD card

Perhaps this problem will come with you too!

And if you did not notice it would be annoying And so .....

I wish everyone a lot of luck with .....With printing or whatever you do.

Friendly greetings from The Netherlands!


  • Link to post
    Share on other sites
    Posted · Attention Software Issue with SD Card!!!

    Hello neotko

    Very good, that was the first thing I thought of!

    So spend a lot of time in it

    But it did not work well after all!


    Maybe I'm doing something wrong, I do not know yet.

    Tomorrow I'll get another SD and try again!

    I will of course come back here to tell you and everyone.

    It was a mini SD card (8GB) (I thought Class 10)

    But other prints did good, only those were small prints.

    (Who knows this is a good learning moment!)

    I'll be back here!

    Kind regards from Rotterdam


  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Talking additive | The 3D printing podcast
        Why should we be the only ones asking questions? Join us and ask Jabil all your questions on September 22nd 5pm CET
          • Like
        • 3 replies
      • Ultimaker masterclass: Optimizing your Ultimaker Cura workflow
        Save your seat for either broadcast on September 23.
        What will you learn?
        · Best practices for iterative print preparation and every lesson you should learn from each print
        · The right way to use per-object settings and when they are most useful
        · Easy-to-use resources for anyone who wants to develop their own printer definitions, plugins, or print profiles
        · How to optimize print profile settings and whether to “keep” or “discard” changes
        · When is the right time to export your drawing from CAD? (Based on Ultimaker Cura’s surprising power as 3D control software)
        · And a whole lot more tips and tricks!
        How can I join?
        This free masterclass will take place twice:
        1. 11am CEST (5pm SGT, 5am EDT)
        2. 5pm CEST (11am EDT, 8am PDT, 11pm SGT)
          • Like
        • 0 replies
      • Do you use 3D printing at work? Let us know
        It doesn't matter if you are using 1 Ultimaker or 10, there is inspiration in everything. We're looking for ...
        • 1 reply
    • Create New...