Jump to content
Ultimaker Community of 3D Printing Experts

After half of the print, print goes wrong


Recommended Posts

Posted · After half of the print, print goes wrong

Hey everybody,

I've got the following problem. The first time I printed the set square, everything went well. After a week or so, I tried printing something else and this started going wrong. So I repeated printing something I knew it should actually work – a second set square. Half of the print went right. The surface became smooth and great. It last about an hour. After that the print started getting wrong. You can see the result in the pictures.

My settings:

PLA as material

Nozzle 0,4mm

Normal quality

The temperature and other settings I can't tell right now because cura says, I wouldnt be connected to the printer and so doesn't tell.

I would be really happy to hear of any idea ;-)

thanks

Anna

  • Link to post
    Share on other sites
    • 2 weeks later...
    Posted · After half of the print, print goes wrong

    I think there is some problem with your printer. It may be due to high temperatue. One of my friend was facing the same problem, but in that case nozzle was not working fine. We change the nozzle and get good prints. If your nozzle is fine, then high temperature may be one of the reason.

  • Link to post
    Share on other sites
    • 2 weeks later...
    Posted (edited) · After half of the print, print goes wrong

    I had this issue with a stubbornly blocked nozzle. Did 25 atomic pulls and it sorted it. Examine the atomic pulls for an imperfections and keep doing it until you have none.

    Cant see any pictures though.

    Edited by Guest
  • Link to post
    Share on other sites
    Posted · After half of the print, print goes wrong

    I think that ur nozzle might be broken. Try to use 0.25 or 0.6mm. If it still doesn't work, check ur slicing and temperature settings(nozzle ~180°C, bed ~60°C).

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...