Jump to content

only printing the exterior

Kool65
 Share

Recommended Posts

Kool65

Kool65 0

Posted
Posted · only printing the exterior

I've been printing for months on this HicTop Prusa I3 and Cura 15.06.6. Today, suddenly, the prints do not print inside geometry. I printed a hinge with screw holes and recesses for nuts. The hinge printed without the screw holes or recess. Thinking it might be my design, I printed a logo from Thingiverse - same issue; just a solid print of the outline. I reloaded the firmware with no change. I tried downloading the new Cura 2.5 but it says my printer isn't installed and I can't find any instruction to install it.

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...