Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted · only printing the exterior

I've been printing for months on this HicTop Prusa I3 and Cura 15.06.6. Today, suddenly, the prints do not print inside geometry. I printed a hinge with screw holes and recesses for nuts. The hinge printed without the screw holes or recess. Thinking it might be my design, I printed a logo from Thingiverse - same issue; just a solid print of the outline. I reloaded the firmware with no change. I tried downloading the new Cura 2.5 but it says my printer isn't installed and I can't find any instruction to install it.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...