Jump to content
Food24

Changes in path planning

Recommended Posts

Posted · Changes in path planning

Dear all,

i have a question very difficult for me: It is possible that by changing some printing variables such as (but not only) print speed (feed rate) a different path of the printer is planned by firmware Marlin ?. If so, should be possible that this takes more time for printing.

My question arise from some results that i obtained in the last days. Particulary, I obtained total (measured) printing time of 150 s, 180 s and 150 s by using print speed of 11, 16 and 21 mm/s. If the setting of other variables are exactly the same i cannot explain this. So, would be possible that at print speed of 16 mm/s a different path is obtained producing an increase of printing time.

Can anyone help me to explain this observation ?

Thanks

Food 24

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!