Jump to content
Ultimaker Community of 3D Printing Experts

G10 and G11 problem using Cura 2.5 release and One at A Time (Ultimaker 2+)


Recommended Posts

Posted (edited) · G10 and G11 problem using Cura 2.5 release and One at A Time (Ultimaker 2+)

Hi

I have just used multiply and one at a time to print a number of small parts on an Ultimaker 2+.

Latest multiply in Cura 2.5 is an improvement.

Unfortunately the first part printed fine but there was no filament extruded on the second part for ages so no skirt and no bottom layers. Looking at the code I see a G10 at the end of the first part which I understand is retraction and then a G11 at the beginning of the 2nd part which I understand should reverse the G10.

I commented out the G10 and the parts all printed OK but with a little stringing. I am therefore sure the problem is caused by the G11 not working. Is this a Cura issue or a Firmware issue (Or even a materials setup)?

Regards

Ian

Edited by Guest
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • Ultimaker Transformation Summit

        On April 20 - April 23 we will host the Ultimaker Transformation Summit. Come talk to us via Live chat and get inspired by any of our relevant presentations!
        • 5 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...