Jump to content
Ultimaker Community of 3D Printing Experts

UM3E reports print finished immediately but prints fine with USB


tmostad
 Share

Recommended Posts

Posted · UM3E reports print finished immediately but prints fine with USB

UM3E reports "print finished" immediately when I print over network but of course prints nothing. I am using the latest Cura (2.5) and latest firmware (3.6.3.20170406). The slicer says that my print will take 13h 35min but when I print to the printer over the network, the printer Active Print printing time says 00:00:00 and the printer says the print is done. I tried to un-install and reinstall Cura 2.5 but it makes no difference. I also switched to recommended settings and it made no difference. I went back to Cura 2.4 and it is printing fine. I also printed to a file and then copied to a USB stick. This also works fine. I'd say this is a bug!

  • Link to post
    Share on other sites

    • 4 weeks later...
    Posted · UM3E reports print finished immediately but prints fine with USB

    I have tha same problem. Ultimaker 3 Ex is printing by networ, but with USB reports print finished immediately. I tryied with Cura 2.4 2.5 2.6. Help!

  • Link to post
    Share on other sites

    Posted · UM3E reports print finished immediately but prints fine with USB

    I've seen this a couple of times. Check and make sure that you have a file name in the bottom right corner of the screen where your STL file is, next to the pencil. I've highlighted it in green.

    5a333b8a49b6c_ScreenShot2017-05-23at9_07_42PM.thumb.png.98e87be630638b23a9520f13465332d4.png

    If the file name is missing from there, the printer will not be able to receive the print correctly and will think the print is immediately done.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...