@RudydG can you share you latest S3D profile, I like to give it try...
I am working on a S3D profile too, I'm focusing on tool change script with idle temperature and a soft acceleration/jerk control.
The latest script is good but not yet perfect.
My current version works good. There was some ooze issues after the printer reads T0/T1 beacuse it unretract immediately the new extruder.
With regard to the expected time and the real one, the maximum incongruity was +8 minutes.
If anyone will try it, let me know if there will be some problems.
https://www.dropbox.com/s/g3bs5chtbjl1qlk/Mark2_1.1.5.fff?dl=0
- 1
Recommended Posts
bob-hepple 59
PLA tec has a higher temperature tolerance... I would personally not use Ngen for this.
Thanks for your Honest Opinion, one of the reasons for not taking advise (neotko) was the link shown for the white was not in English so didn't want to just jump into the Dark.. I Found this on a sight I have purchased from before
https://www.3djake.com/extrudr/green-tec-red
https://www.3djake.com/extrudr/green-tec-white
I presume this is the same Material if so I will order , as always thanks for the comments
Link to post
Share on other sites