Jump to content
Ultimaker Community of 3D Printing Experts
asykesey

Glass plate clips

Recommended Posts

The clips are the single worst feature of the Ultimakers.

 

I can see there are better options possible, but I like the simplicity of the clips.... but you mainly make me wonder what you consider the worst Ultimaker feature?

Share this post


Link to post
Share on other sites

Four leveling screws makes no sense - you always have at least two of them that are fighting each other. Three points define a flat plane, four points are the corners of a 3D prism, i.e. not flat.

  • Like 1

Share this post


Link to post
Share on other sites

Four leveling screws makes no sense - you always have at least two of them that  are fighting each other. Three points define a flat plane, four points are the corners of a 3D prism, i.e. not flat.

Whut he said.....8)

I especially like that the active leveling uses a 90° angle to test against the main 3 screw points used to manually level. Kinda like having a second set of measurements.

I could not find the language for the definition provided...this is spot on.<3

Edited by Guest

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!