Jump to content
termatzor

print is tilted only in bottom layers

Recommended Posts

Posted · print is tilted only in bottom layers

I have built a little 3D corner object to test the alignment of my UMO. Interestingly, the print is strongly tilted x-direction in the bottom layers (3mm) only, the y-direction looks fine. I have already strongly tightened the pulleys as recommended in older posts. This effect appeared from one day of happy printing to the other...

5a333a8525b23_Screenshot-11_05.2017-195238.thumb.png.d39cf6c573835ade3e3774187bcb95f9.png

I am curious to learn your interpretation why this tilt is so much z-dependent.

Thank you,

Mattias

5a333a8525b23_Screenshot-11_05.2017-195238.thumb.png.d39cf6c573835ade3e3774187bcb95f9.png

Share this post


Link to post
Share on other sites
Posted · print is tilted only in bottom layers

Does this happen with other prints as well?

How does your layer view for this print look in Cura?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!