Jump to content
Ultimaker Community of 3D Printing Experts

Monoprice printhead stuck and drip


Recommended Posts

Posted (edited) · Monoprice printhead stuck and drip

Hi, i got the Monoprice 3D printer (15365) and having a lot of issues just from the start.

I have a problem while printing from Cura(2.5) through USB cable - the PrintHead stops at the corner of the build and stays there for several seconds dripping PLA, than makes another line and return to the same spot and drip again until its build up and makes the prindhead to stop.

kTiA9zN.jpg

SWLJXPT.jpg

G6jxDov.jpg

klwEGNO.jpg

4fysvYI.jpg

Edited by Guest
  • Link to post
    Share on other sites
    Posted · Monoprice printhead stuck and drip

    Try printing from SD Card to isolate if this is a USB communications problem, or something else.

    Also check the Layers view in Cura just to be sure there's no command to move the head, drip, print, move back and drip more ;)

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...