Jump to content
Ultimaker Community of 3D Printing Experts

Problem with SD Card


Recommended Posts

Posted · Problem with SD Card

So I finally got my ultimaker and it works nearly perfect.

With the 2GB Card came with the ultimaker, I can work. I see the files.

The Problem is. I've tried some other SD Card (yes old SD Cards from old Cameras), but they doesn't work.

I only see card inserted. And an empty folder stucture.

I've got a macbook pro and formated the card as MS-DOS file system.

Is they problem the filesystem?

 

  • Link to post
    Share on other sites

    Posted · Problem with SD Card

    I know. These cards are 16MB and 32MB and are SD cards.

    The SD cards are ok. I can write and read on them in cameras and my computer.

    Only the ultimaker controller can't read them.

    I think it is a problem with the FAT System. I need the right one.

     

  • Link to post
    Share on other sites

    Posted · Problem with SD Card

    Try to power off the machine, insert card and the power on. My machine strangely doesn't detects SD card inserted, i need to restart it each time...

     

  • Link to post
    Share on other sites

    Posted · Problem with SD Card

    no thats not the problem. When I insert the 2GB Card it refreshes directory instantly.

     

  • Link to post
    Share on other sites

    Posted · Problem with SD Card

    I had the "no card" issue yesterday. The front screen showed "card inserted", but the menu indicated "no card".

    As a side note, I had some difficulty during insertion of the 2 GB card, there was a small bit of plastic that was between a couple of the contacts that broke and was sticking up like a hang nail. I trimmed it off and thought all would be well.

    I disassembled the UltiController and found this - Picture (a bent contact pin on the SD card slot). I was able to bend it back into place and it is, once again, working.

    It was not necessary to remove the longer screws with the stand-offs that are holding the board to the wood cover. I removed the sides and the back only.

    It has been mentioned that SDHC cards are not recommended for the Ultimaker UltiController. This may be the official recommendation, but I had been using 16 GB SDHC memry cards without an issue, except for the above (which is unrelated to the type of card).

    Ben

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...