I like to have manual control on my UM3 over the wifi or LAN. On my previous 3d printers I was able to connect to the printer using Repetier-Host via serial port. After the connection was established, I was able to send gcodes and monitor the response of the 3D printer. But, UM3 does not support serial connection. Do you have any idea how can I manually control it?
Thank you very much in advanced.
Yea UM3 is an open close open system so...
You need to activate Dev mode to get SSH access to your printer then...
and then you need to move to the folder
There you can do
to execute a program that allows direct access to the machine and send gcode commands
Type help once inside the python, if I recall correctly the command is called sendgcode
so you can do, for example:
sendgcode G28 Z0
A full control of the mach