Jump to content
Ultimaker Community of 3D Printing Experts

UM3 bed doesn't stay at 0 degrees, jumps up as high as 60 degrees.


Recommended Posts

Posted · UM3 bed doesn't stay at 0 degrees, jumps up as high as 60 degrees.

I'm trying to print with Taulman Bridge Nylon. With my last print, I had the bed turned off/set to 0 degrees in Cura 2.5, with Elmer's Spray Glue, and I was getting the best bed adhesion after 8 failed prints.

But after a few hours into it, I found that the bed was heating up randomly, causing the the bed adhesion to fail and the print lifting off. When I hit "Abort Print," the display said the bed temp was a 60 degrees!

How did this happen? And how do I prevent this?

Side note, if it helps, the bed was never at actual 0, UM3 was reading it as about 35 degrees, but it was creating great adhesion as is. And if it wasn't for the heat jumping up, I think it would have finished the print just fine, so thats not necessarily a "problem."

  • Link to post
    Share on other sites
    Posted (edited) · UM3 bed doesn't stay at 0 degrees, jumps up as high as 60 degrees.

    You can look 'under the hood' with

    /temperature.html

    Use the ip-address of your printer.

    You will see setpoint, actual value and control value of all heaters.

    Edited by Guest
  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • 18 Visiting our virtual showroom

      1. 1. Have you visited our virtual showroom before?


        • Yes
        • No
      2. 2. If yes - what content did you find most interesting?


        • Information about Ultimaker ecosystem
        • Applications & application stories
        • Customer success stories
        • Webinar sessions
        • Material wall & ecosystem partners
        • New product introduction; software subscription plans
      3. 3. What of the below would make you consider visiting (again)?


        • New Live Ultimaker Webinar streams
        • ‘Ask Me Anything’ with industry experts or Ultimaker staff via main stage and public chat
        • New customer success stories
        • New applications
        • Presentations/news from ecosystem partners
        • Opportunity to meet representatives for an interactive tour
        • Helpful videos like Software tutorials
        • Other; leave input in a comment below!

    • Our picks

      • Ultimaker turns 10: A look back
        Ultimaker is turning 10 years old and that means it is story telling time! We'll explore 2010-2014, traveling through the evolution of the business from the Protobox and Ultimaker Original, to the major leaps forward with the Ultimaker 2 and Ultimaker 3.
          • Like
        • 0 replies
      • Ultimaker Transformation Summit
        Visit our virtual showroom and learn more about the Ultimaker ecosystem!
        • 14 replies
      • New here? Register your Ultimaker for free 3D printer onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 0 replies
    ×
    ×
    • Create New...