Bug in Exporting Routine

[Chaos_Lord 0]

Since the newer Versions of the Ultimaker Firmware, the display shows the Diameter of the Nozzel from the selekted print. However, it can not show the right Data because Cura seems whatever you put as nozzel in the GUI 0.4mm as Diameter. When you change this in the G-Code via Editor after the export everything is shown correct.

I guess this is a littel bug in the export routine, since the direct selection of the nozzel is a new feature.

C Ya

Steve

[CarloK 201]

Thanks for reporting the bug. It is working fine for the UM3 but fails on UM2(+).

It is a known issue and will be fixed in the next Cura release.

[CarloK 201]

Cura v2.6.1 was released today and fixes the export of the nozzle size info for the UM2(+).