Jump to content
Ultimaker Community of 3D Printing Experts

Bug in Exporting Routine


Recommended Posts

Posted · Bug in Exporting Routine

Since the newer Versions of the Ultimaker Firmware, the display shows the Diameter of the Nozzel from the selekted print. However, it can not show the right Data because Cura seems whatever you put as nozzel in the GUI 0.4mm as Diameter. When you change this in the G-Code via Editor after the export everything is shown correct.

I guess this is a littel bug in the export routine, since the direct selection of the nozzel is a new feature.

C Ya

Steve

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...