Jump to content
Ultimaker Community of 3D Printing Experts

Cura Raft Fan Speed settings bugged?


Tobitulpe
 Share

Recommended Posts

Posted · Cura Raft Fan Speed settings bugged?

My printer (no UM) wont print a raft without the fans on. Trying to archieve this i ticked every button in Cura to get them running. Still Cura gives a M107 command (which means "fans off") in between each layer of the raft in gcode. What am i missing?

Thanks in advance

Tobi

Cura.thumb.jpg.3b39220a9c4ae69cda6c1d7c8503482e.jpg

Cura.thumb.jpg.3b39220a9c4ae69cda6c1d7c8503482e.jpg

  • Link to post
    Share on other sites

    • 2 weeks later...
    Posted · Cura Raft Fan Speed settings bugged?

    I can confirm I'm having the same bug.

    My printer is a Dagoma Discovery 200. An old model from a french startup that has a "small" flaw in it's design : it has one fan for cooling both the part and the hotend.

    It's a PLA only printer, so it's not a problem to blow on the plastic all the time. But when the fan is shut down (M107) the heatsink on the ED3V6 hotend became hot, the heatbreak doesn't do it's job and plastic get stuck in the hotend, resulting in failed prints.

    And Cura 2.6.1 is setting the fan off when printing raft, even with the parameters to set a fan speed during raft is put to some value that makes sense.

    I'm currently editing gcode by hand to prevent this so that I don't have failed prints all the time, but it's a bit annoying ^^"

    Where do we reports bugs, on theses forums, or on the Cura GitHub page?

  • Link to post
    Share on other sites

    Posted · Cura Raft Fan Speed settings bugged?

    Absolutely post on github - you get so much better results and faster results and faster discussion (if desired by the programmer) if you post this as an issue on github.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...