Jump to content
Ultimaker Community of 3D Printing Experts

upgrade ultimaker 2 to 2+ without changing the mainboard

Recommended Posts


I was searching on the forum but I didn’t find an answer. Probably my method of searching is wrong.

Is possible to upgrade my printer to a ultimaker2+ with only changing the feeder.

Can I use the original main board and update the firmware to the ultimaker2+ ?

If so, is it just updating the firmware to 2+ via cura 2.6….. or did I need to make modifications with the arduino software?

Thanks in advance,

Share this post

Link to post
Share on other sites

So when I buy a feeder I'm done with it?

Can I just update the firmware via cura to ultimaker2+?

It depends a little on the feeder you buy, but basically: yes on both questions. If it does not work, you can also easily flash an ultimaker2 firmware back. And finally, you can also tell Cura you have an Ultimaker 2+ while still using the Ultimaker 2 firmware.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 122 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!