Jump to content
Ultimaker Community of 3D Printing Experts

Cura 2.6.2 Retraction Settings


Recommended Posts

Posted · Cura 2.6.2 Retraction Settings

I just started using 2.6.2 with my new UM3. Previously I was using 2.3 with my UM2.

My UM3 has a lot of strands all over it after a print. With my UM2 and Cura 2.3 I would adjust the retraction settings to get rid of those but I can't find that in 2.6.2.

Is there a way to adjust the retraction settings in Cura 2.6.2?

  • Link to post
    Share on other sites
    Posted · Cura 2.6.2 Retraction Settings

    Should be under Material -> Enable Retraction

    If you don't see it there, you may have to enable all option:

    Preferences -> Configure Cura -> Settings -> Check All

    Hope this helps.

    • Like 1
    Link to post
    Share on other sites
    Posted · Cura 2.6.2 Retraction Settings

    If you don't see it there, you may have to enable all option:

    Preferences -> Configure Cura -> Settings -> Check All

    A better tip is to use the search box on top of the settings in the sidebar. I would strongly advise against just making everything visible because it gets overwhelming quickly. Just make the settings visible that you use often, and use the search for the rest.

    • Like 1
    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...