Jump to content
Ultimaker Community of 3D Printing Experts

x & y axis seized


kervert

Recommended Posts

Posted · x & y axis seized

ok. so yes both are seized up. by can't move them manually, i meant by hand, and i just checked and that does not change when unplugged. i can try to lube them, but i don't think that's going to help as they did not get worse over time. they went from smooth to stopped. it's not that they move a little, sluggishly. they don't move at all

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...