Autoleveling

[esteban-pacheco 33]

Hello! i keep receiving this message on my U3 that th difference of the cores height s blah blah blah. i did manual levelling like one million times and the autoleveling keep failing, nozzles are clean, glad plate is clean and without any debris... maybe is the sensor that is damaged?

if yes how to change it?

best

Esteban

[Nicolinux 288]

Looks like the printer is not saving that info. Could you try two things?

1. Disable automatic leveling and see if the message disappears.

2. Enable developer mode, ssh into your printer and check the free disk space.