Jump to content
Ultimaker Community of 3D Printing Experts
GeorgeReis

UM2+Extended Printing Problem

Recommended Posts

I started using a full raft with printing because of a warping issue that I was having. Now I'm experiencing an issue where the raft prints perfectly, but the first layer of the item I'm printing has a lot of weird issues. It almost looks like my platen isn't level - but the raft prints perfectly, as do all layers above the first true layer. I've attached an image to show the problem. Can anyone suggest what I'm doing wrong?3D_Troubleshoot.thumb.jpg.3ed5f02354f7f73ae07db6e866e483eb.jpg

3D_Troubleshoot.thumb.jpg.3ed5f02354f7f73ae07db6e866e483eb.jpg

Share this post


Link to post
Share on other sites

It looks like there is a Z-axis Offset issue on that first layer. If the head is too close the the bed, or in this case the previous layer, Hydraulic pressure will build up under the head as it tries to lay down filament causing it to force out around the head. Try to calibrate the Z-axis and see if it fixes your problems.

I'm not sure what material you are using, but try increasing the bed temperature to help with warping issues.

Share this post


Link to post
Share on other sites

Thanks - I am using PLA, with the following parameters:

Layer Height .15mm

Print Speed 60mm/s

Travel Speed 150mm/s

Initial Layer Z Overlap .15mm

Temps are all at default settings

I've re-calibrated my platen with the same results. Thanks in advance for any suggestions.

Share this post


Link to post
Share on other sites

Slow down the printing speed to 20 for first layer and 40 overall, this will make it longer but make the quality much better and help it overall, make the travel speed 60, And in my case since i use abs i set my fan speed to 50% and make each layer at least 10 seconds, this'll ensure that it doesn't go too fast and give it time to harden so it wont lift or warp.

Hope this helps!

Share this post


Link to post
Share on other sites

I agree with @Legendary_zotar that your speeds are ambitious but my speed recommendation would be 45-50mm/s print speed, infill speed 55mm/s or less, travel speed I use 150mm/s

Most of these parameters can be machine specific, for example I have an Olson block, use matchless nozzles and have a BondTec feeder, all of these improve print speed

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Print Core CC | Red for Ruby
      Q: For some users, abrasive materials may be a new subject matter. Can you explain what it is that makes a material abrasive when you are not sure which print core to use?
      A: Materials which are hard in a solid piece (like metals, ceramics and carbon fibers) will generally also wear down the nozzle. In general one should assume...
      • 1 reply
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!