Jump to content
Ultimaker Community of 3D Printing Experts


Recommended Posts

Hello UM Gurus,

I think my extruder stepper driver and motor died. The extruder motor is not moving whenever I'm doing a print. Here's a bit of explanation of what happened.

1. Last time the extruder motor worked, the UMO would print but about 5-7 minutes into the print, the

filament would stop extruding. The motor will not spin/move anymore.

2. Flipped the UMO over and looked at the extruder stepper driver on the board and found that it's missing

the heatsink. The other stepper driver has the heatsinks on them.

3. Took the extruder stepper driver from my 2nd UMO, and installed it on the the UMO that has a problem,

but carelessly (stupidly) installed in the wrong way. It should have been installed 180 degree in relation

to the other stepper driver on the board. Can someone please confirm this.

4. Tested if the stepper motor is still good by plugging it on the z-axis and moving it forward in 1mm

increments using the Ulticontroller. It still moves forward but not backward/reverse.

Can anyone please confirm if both died, and where can I get a replacement. Would the ones on ebay or amazon work. Thank you for your help.




Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 130 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!