Jump to content
Ultimaker Community of 3D Printing Experts
Gafair

Artifacts in Cura slicing software

Recommended Posts

I've been using Cura for about three years now on all my printers, Wanhao i3 plus Mono price V2 CR 10 and Japanese i3

Only recently have had problems and every one of my prince there's an artifact a quarter way up that sends the machine into a searching. And doesn't seem to know what to do. the artifact appears as two squares hanging off two sides of the front that only seen when I look at layers in Cara slicing

Any suggestions would be helpful. very confident with Cara trying to use other slicing software is going take me a little bit of time

Thank you

Monty

IMG_2096.thumb.JPG.cf13dd0f8d27d878c0d913ca4eb6cc2d.JPG

IMG_2096.thumb.JPG.cf13dd0f8d27d878c0d913ca4eb6cc2d.JPG

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Taking Advantage of DfAM
      This is a statement that’s often made about AM/3DP. I'll focus on the way DfAM can take advantage of some of the unique capabilities that AM and 3DP have to offer. I personally think that the use of AM/3DP for light-weighting is one of it’s most exciting possibilities and one that could play a key part in the sustainability of design and manufacturing in the future.
        • Like
      • 3 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!