Jump to content
vikas_gupta

Homing in dual extrusion.

Recommended Posts

Posted · Homing in dual extrusion.

Hi, I am using cura 2.6.2 and 2.7 in dual extruder. I have a question. I have seen some videos, where whenever nozzles swap (means between nozzles 1 pauses and nozzles 2 starts), print head goes to home position or away from print. Is there any setting or option that I should enable in cura for that? I am frustrated with oozing problem. Thanks in advance.

Share this post


Link to post
Share on other sites
Posted · Homing in dual extrusion.

Which printer do you use? Depending of the printer type, the gcode type has to be set in Cura.

  • Like 1

Share this post


Link to post
Share on other sites
Posted · Homing in dual extrusion.

Which printer do you use? Depending of the printer type, the gcode type has to be set in Cura.

Thanks Nicolinux for replying.

I have XY-Z configuration printer with core xy. Two e3d hotends. Bowden extruder.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!