Cura 2.7 and UM3...Not sure to understand one of the double extrusion setting !

[thewarlab 3]

Hi All,

Just unpacked my UM3 ! Amazing...a huge step forward compared to UM2+.

For each part I try to print CURA is creating a second "print" in the top right corner for the support material ?

In this case the print is a dragon head in green...I tried several different model but still have this red support "tower" on the side !

Did I miss Something ?

Thanks,

TWL

Edited October 1, 2017 by Guest

[Dim3nsioneer 557]

I recommend to newbies to check the Cura ressource pages on the Ultimaker website, in your case especially this one here: https://ultimaker.com/en/resources/49701-dual-extrusion

[thewarlab 3]

Thank you very much.

[DidierKlein 729]

That second print is called the prime tower you can set or unset it under the dual extrusion options