Jump to content
paul9

Printing problem after a factory reset

Recommended Posts

Posted · Printing problem after a factory reset

Today I did a factory reset and after that I started to have the following problems.

The printer creates problems after printing the first layer.

The subsequent layers of filling are all detached one with each other.

I tried to lower the current values of the stepper motors first to 1100 mA and then to 1000mA but nothing changed.

Where is the problem?

Laproblem.thumb.jpg.14c5b09bba944ccfbc7f5ce6d70fba6b.jpg

Share this post


Link to post
Share on other sites
Posted · Printing problem after a factory reset

Do you use a different extruder than the original one?

Then you need to adjust the steps/mm.

Share this post


Link to post
Share on other sites
Posted · Printing problem after a factory reset

There are many things that go back to "default" when you do a factory reset including all the steps/mm settings. Particularly, like conny_g, I'm guessing you messed around with Z steps/mm long ago? Does that sound possible?

Alternatively it could be the extruder steps/mm.

I would calibrate both. Move the Z some distance such as 100mm and then check that it moved the correct amount. Repeat with the extruder.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!