Jump to content
Ultimaker Community of 3D Printing Experts

Maximum Build Volume


Recommended Posts

Posted · Maximum Build Volume

I have been the page https://ultimaker.com/en/resources/44677-maximum-build-volume-ultimaker-2-plus-ultimaker-3 and followed the instructions. But I cannot get a 195 x 195 square to slice on an Ultimaker 3 Extended using Cura 2.7.

I downloaded the profile and use that - it does not work

I follow the detail to set manually - it does not work

What am I missing?

The spec sheet states Dual material: 197 x 215 x 200 mm as the maximum build volume.

  • Link to post
    Share on other sites
    Posted · Maximum Build Volume

    Could you share with us a screenshot of your buildvolume to see what you have done and which areas are preventing you from printing?

    I am guessing you have the prime blob still enabled (under build plate adhesion).

    If you deselect it you should be able to print a 195x195x195 cube. Good luck!

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...