UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Then their official statement is wrong. You can get it to work with static ip's. The ultimaker just runs linux. So if you can get it to run on linux, you can get it to run on the UM3+. Granted, you need to put it in dev mode, but it's doable. What the re-seller is trying to say in legalese (I think); "We don't know, therefore we don't support it. Change it, you are on your own"
Another option is to just set the lease of IP adresses on your router to be longer. Thats also what we do in the office here. Works like a charm. My printer has had the same IP for months now.
As for the calibration; they are right. The shrinking of the model is based on it's geometry and the material. It's possible to find settings that work for one material, but those are pretty much guaranteed to not work for another material.
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
nallath 1,120
Then their official statement is wrong. You can get it to work with static ip's. The ultimaker just runs linux. So if you can get it to run on linux, you can get it to run on the UM3+. Granted, you need to put it in dev mode, but it's doable. What the re-seller is trying to say in legalese (I think); "We don't know, therefore we don't support it. Change it, you are on your own"
Another option is to just set the lease of IP adresses on your router to be longer. Thats also what we do in the office here. Works like a charm. My printer has had the same IP for months now.
As for the calibration; they are right. The shrinking of the model is based on it's geometry and the material. It's possible to find settings that work for one material, but those are pretty much guaranteed to not work for another material.
Link to post
Share on other sites