Jump to content

Cura 2.7.0 Bed Levelling issue on UMO

malkorum

By malkorum
in UltiMaker Cura

 Share

Recommended Posts

malkorum

malkorum 0

Posted
Posted · Cura 2.7.0 Bed Levelling issue on UMO

When I run the bed levelling wizard in Cura 2.7.0 the second position it reaches causes the fan to sit directly on top of the screw I need to adjust the level on my Original Ultimaker. This is a particularly annoying oversight.

For this reason I keep around a copy of Cura 15.04.6 to level my bed but it would be nice not to have to.

Are there any workarounds available?

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...