Jump to content

Center of bulidplate and center defined by Cura are not the same.

anshuman

By anshuman
in UltiMaker Cura

 Share

Recommended Posts

anshuman

anshuman 0

Posted
Posted · Center of bulidplate and center defined by Cura are not the same.

Cp.thumb.jpg.28b1d48d4f5955e23a59103403b49470.jpg

what are the reasons for the offset in the center point of the buildplate.

the Second diagram in the picture i have uploaded shows the center point which i calculated by printing a small circle of 1mm radii at [0,0] cordinate in Cura..

Cp.thumb.jpg.28b1d48d4f5955e23a59103403b49470.jpg

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.4 stable released

        UltiMaker Cura 5.4 stable released

        ArunC posted a topic in UltiMaker Cura,

        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...