Jump to content
Ultimaker Community of 3D Printing Experts

Center of bulidplate and center defined by Cura are not the same.


anshuman

Recommended Posts

Posted · Center of bulidplate and center defined by Cura are not the same.

Cp.thumb.jpg.28b1d48d4f5955e23a59103403b49470.jpg

what are the reasons for the offset in the center point of the buildplate.

the Second diagram in the picture i have uploaded shows the center point which i calculated by printing a small circle of 1mm radii at [0,0] cordinate in Cura..

Cp.thumb.jpg.28b1d48d4f5955e23a59103403b49470.jpg

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...