Dim3nsioneer 528
You may also want to try a different USB cable.
Edited by Guest-
Our picks
-
Special introduction: Ultimaker Cura engine improvements with Arachne alpha
SandervG posted a topic in Ultimaker Cura,
We don't often release an alpha version of Ultimaker Cura... So what's different this time? This Alpha contains such a huge slicing engine overhaul that we really need your help!-
-
- 7 replies
Picked By
SandervG, -
-
Ultimaker Innovators list 2020
SandervG posted a topic in Official news,
We wish to celebrate and honor the innovators that push forward the field, technology and world. We opted to not present it as a competition or ranked list. Every innovator has earned his spot on that list in their own way. We also look at the 3D printing industry as a whole and not limit the list to those only using Ultimaker.-
-
- 3 replies
Picked By
SandervG, -
-
Recommended Posts
ultiarjan 1,209
don't know what the latest firmware is, as I use tinker firmware myself.
If you can't update from cura 3.0.4 you can try to update from an older (15.xx) version of cura. You can install the 15.xx version next to the new cura versions.
Just select "install custom firmware" and select the correct .hex file in the folder of your cura 3 installation. (C:\Program Files\Cura 2.7\resources\firmware)
In general there's no real point to update the firmware on a Ultimaker2 with every cura update, as there are not much developments in it anymore (compared to the UM3, where you should update firmware....)
Link to post
Share on other sites