Jump to content
jvanderslik

Error - Could not save to/ ......gcode: [Errno 30] Read-only file system.

Recommended Posts

Posted · Error - Could not save to/ ......gcode: [Errno 30] Read-only file system.

When I try to save a file from cura to the ultimaker SD-card it gives this error.

Card is not locked by the lid.

I tried both Mac and windows.

How can I transfer a file to the SD card?

Share this post


Link to post
Share on other sites
Posted · Error - Could not save to/ ......gcode: [Errno 30] Read-only file system.

I'd get another SD card.

Are you sure you don't have lock/unlock backwards regarding the little switch on the SD card?

Share this post


Link to post
Share on other sites
Posted · Error - Could not save to/ ......gcode: [Errno 30] Read-only file system.

try it multiple times, again and again, I have several cards with the same issue, or use an usb/sdcard extension.

Share this post


Link to post
Share on other sites
Posted · Error - Could not save to/ ......gcode: [Errno 30] Read-only file system.

Thanks, I figures out the problem.

The cars was connected to the PC with a card reader..

Direct plugged in SD card worked fine.

Card reader, is what the name indicates, just a reader I think.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!