Jump to content
Ultimaker Community of 3D Printing Experts
ruggbg

view layers bottom to top

Recommended Posts

I am just getting to Cura - 3.04 or 15.04 - not sure why there are 2 numbers for the same thing???

I want to view my sliced model layers from bottom to top, but I get only top to bottom. How do I change that??

ALSO, Is the How To for 2 to be used with 3? I assume it is cause there is not very much under the 3 how to.

thanks

bill

Share this post


Link to post
Share on other sites

cura 15.04 is from april of 2015 (2015.04).

Cura 2.7 and cura 3.04 and inbetween are all very very similar versions of Cura. So any manual for 2.7 is relevant for 3.04 with minor changes.

Don't know what you mean only top to bottom. Cura 3.* has a dual slider so you can see a range of layers including all of them or only some range of layers. Is that what you mean?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!