Jump to content

Recommended Posts

Posted · Mark 2 Extension Board Wiring

Hi I have begun wiring the Mark 2, Mod using Syntax Terrors Extension Kit there is a 6 way ribbon connector that meets a six pin header, it is extremely tight fit and I wondered does only three of these pins marry up with the Locking Ribbon Cable Header,

to get all 6 marry up is very tight and it looks like the pin spacing is larger on the header...

hence I thought I would ask before I screw it up..

Thanks in advance

Share this post


Link to post
Share on other sites
Posted · Mark 2 Extension Board Wiring

Strange.... Long time ago but I had no such problem and just an easy fit. Can you share a picture?

Share this post


Link to post
Share on other sites
Posted · Mark 2 Extension Board Wiring

Ultiiarjan

Thanks for the reply I managed to get the cable header on very snug fit all six pins connected.. Just being over cautious

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!