Jump to content
Ultimaker Community of 3D Printing Experts

Ultimaker 3 with firmware 4 is not geting IP address. Arp table Incomplete


Recommended Posts

Posted · Ultimaker 3 with firmware 4 is not geting IP address. Arp table Incomplete

Hi all,

I am just setting up an ultimaker 3 extended in a company network and to my surprise the system cannot assign the right IP address to the printer because the MAC address can not be found in the arp table.

I check that and what it shows is this:

169.254.204.192 (incomplete) eth0inlocal

This test was using a direct connection with the printer over Ethernet. As you can see the mac address appears as (incomplete).

Is there a way to solve this problem? otherwise I would need to configure the printer with a static IP address and configure the right gateway.

  • Link to post
    Share on other sites
    • 2 weeks later...
    Posted · Ultimaker 3 with firmware 4 is not geting IP address. Arp table Incomplete

    Check the information using System -> Network -> Connection status.

    However, the 169 network is a fallback network when it cannot get a network address from a DHCP server (for whatever reason).

    If you can use a direct connection with a PC, setup a DHCP server on the PC. The printer will then get a valid IP address and you should be able to determine the MAC address.

     

  • Link to post
    Share on other sites
    • 3 weeks later...
    Posted · Ultimaker 3 with firmware 4 is not geting IP address. Arp table Incomplete

    If you just want the MAC address it is in the "System -> Network -> Connection status" menu. (It's shows the LAN or WiFi Mac address depending on the selection on the previous menu)

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...