Jump to content
Ultimaker Community of 3D Printing Experts

S3D Probleme mit Dualextrusion (MM-3D-Print)

Recommended Posts


Also ich habe den Drucker nochmal auf Werkseinstellungen zurückgesetzt und die Firmware 16.08.2 aufgespielt.

Der Steckverbinder für die Kühlungsüberwachung ist noch nicht angeschlossen.

Aber ich konnte endlich mal ohne immer Fortsetzen zu drücken einen Druck abschließen.


Werde den Steckverbinder mal wieder drauf machen und gucken obs dann immer noch geht.


Gruß Alex

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 122 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!