Jump to content
Ultimaker Community of 3D Printing Experts
kmanstudios

Just something cool to see--neato 3D printed things in 2017

Recommended Posts

Pretty amazing stuff kman - thanks for sharing.

Very nice new forum. The algorithm and people combo did a great job.

Finally bought a small benchtop oven for $NZ15.00 :) Should be good for drying PLA spools, hardening PLA models and the occasional loaf of homemade bread or pizza. Temp range is from around 25°C to 240°C.

Edited by nzo

Share this post


Link to post
Share on other sites
17 minutes ago, nzo said:

Pretty amazing stuff kman - thanks for sharing.

Very nice new forum. The algorithm and people combo did a great job.

Finally bought a small benchtop oven for $NZ15.00 :) Should be good for drying PLA spools, hardening PLA models and the occasional loaf of homemade bread or pizza. Temp range is from around 25°C to 240°C.

What are the step ranges? For instance I have an electric oven, but it can only go in 5° increments,

 

And, yeah, the forum is nice. Gotta get used to finding things again, but it is speedy and I like that......:)

Edited by kmanstudios

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 114 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!