Jump to content
Ultimaker Community of 3D Printing Experts

auto level - 3 points - before/after firmware update


Recommended Posts

Posted · auto level - 3 points - before/after firmware update

Hi

 

This afternoon I did a firmware update to the Ultimaker 3 I am borrowing. 

 

Before the update, when auto-levelling, the printer choose 2 points in the front (one left, one right) and one in the back (in the middle).

 

After the update, I notice the printer chooses two ponts on the left (on in the front and one in the back) and one on the right (in the middle). 

 

Why ? Is it possible to change this, or to use 4 points ?

 

Kind regards

Diederik

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...