Jump to content
Ultimaker Community of 3D Printing Experts

Nylon model is not sliced on Ultimaker2+


Lionel-MSMI
 Share

Recommended Posts

Posted · Nylon model is not sliced on Ultimaker2+

Halo, I have a model with 198x190x15 dimensions to print with my Ultimaker 2+. When I insert it in Cura 3.1.0, with PLA as material to be used, it is correctly sliced but when I choose Nylon for the same model at the same position, it is not sliced and this error message appears : " Nothing to cut because none of this models corresponds to the impression volume". could some body help, please??

  • Link to post
    Share on other sites

    Posted · Nylon model is not sliced on Ultimaker2+

    If i remember right, the nylon profile adds a large brim to the model. Switch to the custom settings and check the settings in the section "Buildplate Adhesion".

    Reduce the size of the brim until it fits into the build volume.

    Good luck!

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
        • 8 replies
    ×
    ×
    • Create New...