Jump to content
Ultimaker Community of 3D Printing Experts

Recommended Posts

Posted · The dreaded BLOB

Well a few weeks ago, I managed to develop a nasty BLOB in the print head of my Ultimaker 2+

 

No...it wasn't a nozzle leak or anything that bad

 

What happened is I bought a PEI sheet and installed that on my glass bed.  The PEI is very shiny and I didn't do the best job with the bed alignment.  One the last section of the first layer, the print started to come off.  Then the print head started to collide with that material and it got shoved into the fan should and heater block.  Thankfully I was home and near the printer when this happened.

 

I documented how I cleaned it up on my YouTube Channel, here's the video so that if YOU wind up with a nasty mess....it can be fixed!

 

 

 

  • Like 1
Link to post
Share on other sites
Posted · The dreaded BLOB
3 hours ago, Brulti said:

Thanks for the video, I need to get a wire brush now. ^^

 

However, we can't hear a thing once you start cleaning, sound is very low, can barely make out what you're saying.

 

I lowered it since the microphones were doing an exceptional job of picking up the brushing sound  :)

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...