Jump to content
Ultimaker Community of 3D Printing Experts

First layer using cura 3.1 in Repetier-Host


Recommended Posts

Posted · First layer using cura 3.1 in Repetier-Host

I'm using cura 3.1 in Repetier-Host and my question is if I increase the first layer in cura slicer, The height is correct to what I tell it to be but the fulfillment feed rate increase very fast layer than on the 2nd layer it slows back down to where it's set at. What is going on??Is this something in cura it self or something I'm doing wrong????

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...