Jump to content

Printing on different substrates


NSUeng

Recommended Posts

Posted · Printing on different substrates

I have an ultimaker 2+, and and trying to figure out if it is possible to print a structure on anything other than the print bed. Ideally, it would be printed on a silicon wafer, so thermal properties similar to the glass bed, but I was wondering anybody had tried this before considering there would be quite a few hurdles I imagine.

  • Link to post
    Share on other sites

    Posted · Printing on different substrates

    Haven't tried this before but think it would be possible. One thing that would be super important is to level the bed with the wafer on it or else you'll crash the head, as well as make sure you secure the wafer while printing or it might slide and you'd get a shifted print. Other then that it would probably just be a matter of finding a plastic that would bond to the wafer and well as a initial print temp. Good luck, if you try it post pics of how it went.

  • Link to post
    Share on other sites

    Posted · Printing on different substrates

    There are a bunch of compatible substrates. Like for example, polyester clear plastic inkjet shipping labels are perfect — great bonding on the surface designed to accept inkjet, and transmits heat. Also, there are acrylic “digital ground” primers that bond to lots if stuff and similarly allow good cohesion. But the place to start is to look at the technical data sheets for the materials you want to bond to each other. Find out if they actually repel each other — requiring priming or mechanical cohesion strategies such as crushing the new material into the substrate so that you are tearjng down into it a bit and using the tip of the nozzle to iron.

     

    As pdrinkut says, the key thing is knowing that top surface calibration to nozzle, which you can cheat by the above trick of “tramming” by running a top surface that is a bit lower (thus thinner) than you would print on a calibrationed glass bed, so that by the time you get a few layers down, you are printing on a surface corrected to your nozzle.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.8 Stable released 🎉
        In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
        • 5 replies
      • Introducing the UltiMaker Factor 4
        We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
          • Thanks
          • Like
        • 3 replies
    ×
    ×
    • Create New...