Jump to content

After each print in PLA on UM2E+ nozzle remains on top layer, causing local melt in surface

PjotrDuMat

By PjotrDuMat
in Improve your 3D prints

 Share

Recommended Posts

PjotrDuMat

PjotrDuMat 0

Posted
Posted · After each print in PLA on UM2E+ nozzle remains on top layer, causing local melt in surface

Today, I ran some tests with default PLA settings, on two Ultimaker 2+ Ext.

After the job was done, the nozzle remained on the last layer, at one of the layer's edges. This of course affected the piece's surface as I do not want it to happen.

I didn't experience this before.

What is wrong ?  Setting ?  Bug is updated software ?

Tnx, Rein

    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing
    ×
    ×
    • Create New...