Jump to content
Ultimaker Community of 3D Printing Experts
Gigi

PLLA and PCL filaments on Ultimaker 3

Recommended Posts

Probably you will have to make your own profiles for those two materials. For PLLA you probably can start with the PLA profile adjusting a few settings. PCL could be more tricky as such low print temperatures are maybe not allowed (cannot check Cura atm).

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!