Jump to content
Ultimaker Community of 3D Printing Experts
3ddrucker

Updated Ultimaker 2+ board needs to cool down

Recommended Posts

I have an uptdated Ultimaker 2+. After changing the board from version 2.1.1 to 2.1.4 (with the older version the printer lost the gcode for a little time, so that the z-axis lost his position) I can not start the printer. It leveled the z-switch and than stucks the stepper with an ugly nois. I proved the z-switch, it gives the sign to the board. cura is download Version 2.6.2. After it I changed back the old board, and printer start as usual. I am cooling the stepperdriver with heat sinks and the printer works with the old board about 1 hour without problem. Before cooling it works only for a few minutes. Can you give me an advice what I can do to work with the controllerboard version 2.1.4.? Thanks for your Reply.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!